discharge state meaning in Chinese
排汽管中的状态
Examples
- It is discovered that a process of mea activation may greatly shorten the time needed for the dmfc to attain to the best discharge state , which is though not changed by it
本工作首次发现膜电极的活化过程虽然不会改变dmfc的最佳放电性能，但可以大大缩短电池到达最佳放电状态的时间。 - The result shows that argon gas can not only promote the excitation of plasma at low pressure , but also improve discharge state , increase the density and activation of reaction radical and improve the quality of diamond films . on the other side , argon can cool the plasma and maintain low temperature of substrate due to its big ionization section and high collision probability with gas molecules
结果表明，气体系统中引入氩气一方面不仅有利于维持低压放电，而且改善放电状态，提高反应活性基浓度和活性，提高低温沉积金刚石膜的质量；另一方面，由于其大的电离截面使其和电子碰撞的几率大大提高，对等离子体进行冷却，有利于基片温度的降低。 - By using a counter and an operation microprocessor , this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state . this instrument takes samples of voltage , current signal and strong and weak of high frequency signals of detecting voltage amplitude , translates them into various time pulses in discharging state . and a counting unit turns these pulses into digital signals , then send them to a microprocessor . finally various discharge time percentages are sent to the control tache
通过采样电火花加工放电间隙的电压、电流信号和检测电压幅值上的高频信号的强弱，得出反映间隙放电状态的各种时间脉冲，利用计数器分别对其计数，再送给单片机运算处理，输出控制环节所需的各种放电状态时间百分数。 - Abstract : by using a counter and an operation microprocessor , this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state . this instrument takes samples of voltage , current signal and strong and weak of high frequency signals of detecting voltage amplitude , translates them into various time pulses in discharging state . and a counting unit turns these pulses into digital signals , then send them to a microprocessor . finally various discharge time percentages are sent to the control tache
文摘:通过采样电火花加工放电间隙的电压、电流信号和检测电压幅值上的高频信号的强弱，得出反映间隙放电状态的各种时间脉冲，利用计数器分别对其计数，再送给单片机运算处理，输出控制环节所需的各种放电状态时间百分数。